Rearend

DSC00003.JPG (98026 bytes)DSC00004.JPG (92722 bytes)DSC00005.JPG (88999 bytes)DSC00006.JPG (88405 bytes)DSC00007.JPG (84585 bytes)

DSC00008.JPG (101310 bytes)DSC00009.JPG (85917 bytes)DSC00010.JPG (86096 bytes)DSC00011.JPG (73751 bytes)DSC00012.JPG (75702 bytes)

I found this rear end on ebay and could not resist as it is new and
out of a single rear wheel 2001-2003 one ton GM truck. This should
more than enough for my 3/4 ton and it already has the rear disk brakes
with integrated parking brakes. I have removed all the brackets and
ground off the welds using my precision calibrated hammer and grinder.
I plan to purchase new spring perches and have them welded on.
I did have a tool casualty while trying to remove the brackets.
I managed to break the tip off of a regular screw driver.
I know better to use tools properly and that a screw driver is
NOT a wedge, chisel, or pry bar.

Up ] Wreck ] Front clip ] Old Engine ] Cab ] Frame ] Frame Painting ] Frame Assembly ] [ Rearend ] Exhaust ] New Engine ] Cab Repair ]